[wpdatatable id=96 table_view=regular]
Replacing cast iron pillow block ball bearings of UCP 218
If a bearing insert needs to be replaced, it is not always necessary to replace the housing, if the housing
is undamaged.Simply insert a new bearing into the old housing, after care fully inspecting the housing to assure that it is not damaged.
Replacement procedures for a bearing insert are listed below.
(1) Remove the complete bearing unit from the shaft and mounting base.
(2) Screw in the set screws so that the head of the set screw does not protrude outside the 0.D. the inner race. Otherwise the head of the set screw may damage the bearing seat inside the housing.
(3) Turn the bearing 90° with a hammer handle or a bar or pipe until the bearing is horizontal.
(4) Remove the bearing insert from the housing via the bearing groove in the housing.
Reverse the above procedure to put in a new bearing insert. Insure that the set screws are screwed in before proceeding with the replacement.
Wholesale UCP 218 | UCP 218 Supplier
Welcome to UCP 218 manufacturer– NSAR, your trusted UCP 218 pillow block ball bearings factory in wholesale UCP 218 pillow block ball bearing! As leading UCP 218 pillow block bearing manufacturer in the bearings industry, we take immense pride in providing top-quality UCP 218, including UCP 216,UCP 217. NSAR offers a wide range of UCP 218 at the most competitive prices,which will provide you with a great shopping experience.
